Dále mi dovolte stručně představit definice pinů konektoru DB9 a konektoru Phoenix. Nálepka na předním panelu snímače označuje funkce pinů konektoru DB9. Pro tento snímač jsou platné pouze piny 4, 5 a 9.

• Pin 4: Zem (0V referenční napájení) – pozor, jedná se o referenční zem napájení, nikoli ochrannou zem.
• Pin 5: Záporný napájecí zdroj (V-).
• Pin 9: Positive power supply (V+).
  Essentially, these are only used for power supply.
  For the 6-pin Phoenix terminal, only pins 5 and 6 are actually used:
• Pin 5: Output ground.
• Pin 6: Voltage output.

Here is the power cable we have pr-connected according to the DB9 pin definitions. To use it, simply insert the DB9 female connector of this matching cable into the DB9 socket on the transducer panel, and tighten the fixing screws on both sides. Then connect the other end of the cable to the +15V, GND, and -15V terminals of the power supply respectively. This completes the power wiring.

Next, let’s connect the 6-pin Phoenix terminal. First, plug the 6 pin Phoenix terminal connector into the socket. Based on the pin definitions, connect the output power line and the output ground line. Connect the output power line to the positive terminal of the 6½-digit multi-meter’s voltage input and the output ground to the ground terminal of the multi-meter. This completes all wiring.